Pwm Stepper Motor Controller Pulse Signal Generator Speed Regulator Board Adjustable Frequency Regulator Motor Driver

Description

This module is provided as a stepper drive signal. To control the stepper motor, but also must have the drive to use. The controller has a high, medium and low total of three kinds of frequency signals, which can be used to select a jumper.

The measurement frequency can reach two ports PUL and GND (common cathode terminal). It is possible to control the forward and reverse of the motor by pressing the key. Motor speed can be controlled by adjusting the frequency of the potentiometer. PUL+ and PUL-pulsed positive and negative; EN+ and EN- should activate the positive and negative terminals; DIR+ and DIR- are the positive and negative directions. These six lines are connected to drive the corresponding pulse, direction, so six ports p Power supply: 15-160VDC or 5-12VDC. If using DC 5-12V power supply, connect positive end to DC 5-12V input, connect negative end to common cathode end. The forward and reverse of the motor can be controlled by pressing the key.